Rode pro microphone2/2/2024 ![]() Maximum SPL: 134dB 1kHz, 1% THD into 1k ohm load) Maximum Output: +6.9dBu 1% THD into 1k ohm) Sensitivity: -32 dB re 1V/Pa (20mV 94dB SPL) ± 2dB 1KHz The VideoMic pro is battery powered, and provides over 70 hours recording from a single 9V battery.įrequency Range: 40Hz - 20,000Hz (selectable ) The microphone uses a standard sized shoe mount for on camera use, and features a 3/8 inch thread in the base of the mount for easy boom pole mounting. ![]() ![]() The +20dB level boost is designed for use with DSLR cameras, allowing the user to reduce the camera's preamp level (or mic-input level), effectively reducing the amount of noise generated by the camera's comparatively low quality audio circuitry. The -10dB level attenuation (or PAD) is ideal for recording loud sound sources, such as live music, motorsport, or interviews where the subject is very close to the camera. In addition to the microphone's native 40Hz-20kHz response a selectable high-pass filter at 80Hz is available, which will prevent low end noise such as air conditioners and traffic from being recorded.īelow these controls are the level settings, which attenuate or boost the recorded level as required. Constructed from a single piece of hard-wearing thermoplastic, the Lyre® provides superior acoustic suspension to traditional elastic solutions, and will never wear out, sag or snap.Įasily accessible on the rear face of the microphone are the power, filter and level controls. The integrated Rycote® Lyre® based shock mounting system separates the VideoMic Pro capsule and electronics from its mount, providing isolation from external physical factors that may cause unwanted rumble and vibrations in the microphone. A super-cardioid polar pattern ensures that surrounding audio is minimised, and your recording is focused on the subject in front of the camera. The Rode VideoMic Pro is a true shotgun microphone designed for use with camcorders, DSLR cameras and portable audio recorders as a source of primary and reference audio.Īt the heart of the VideoMic Pro is an all-new 1/2 inch condenser capsule that provides broadcast-quality audio via a 3.5mm minijack connector (outputting the mono signal to both left and right channels) with an incredibly low self-noise of just 14db. Camera shoe mount with 3/8 inch thread for easy boompole mounting.3.5mm stereo mini-jack output (dual mono).9V battery powered - over 70 hours use (alkaline).Broadcast recording quality condenser microphone.All new capsule with lower noise and higher sensitivity.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |